How to Install Custom Carpet Runners for Stairs


Add warmth and color to your home by installing custom carpet runners for stairs, which also maintains the integrity of the staircase. A thin but touchpad is placed on each step before mats are installed, damping noise and preventing premature wear. Tackless strips, matte nails, and narrow crown staples keep your carpets while causing minimal disturbance to the stairway treads. Stair runners may be made of synthetic fibers, a synthetic/wool blend or 100 percent pure wool. Prices are stepped up with the amount of wool in the twine and also varies between the most common 27-inch and 32-inch widths. Custom widths can cost you a lot more.

Instructions Measure and subfloor

Measure the width of your stairway along the flat surface – stairway tread – one step. This measure determines the width of the stair runners who look best on your stairs. Subtract the width of your chosen best carpet runners for stairs from the width of the stairs and divide this number two. This is the distance you should measure and land with your pen from both ends of each staircase where it meets the tier.

Place a piece of scrap tackless strip flush against the stand to use as a spacer stair runners lowes. Center the measured tackless strip between the pen mark you did in step 2. Butt measured the strip against the scrap spacer strip and nail the measured strip in place. Repeat for each tread. Measure and cut matte pillows to the same width as your installed tackless strips and 3 inches further than the depth of your stairway tire pattern. Place your mat pad on the front of the installed tackless band.


Comments are closed.